Happy Thanksgiving from Bailiff Enterprises! Our office and plant will be closed Thursday, November 26 and Friday, November 27, 2026. We reopen Monday, November 30.

Fittings & Options · Fill & draw-off

Top Drain Lines, Siphon Tubes & Welded Pipe Supports

How liquid gets out of a tank matters as much as how it gets in. Along with top fill lines, we build top drain lines and siphon tubes so you can draw liquid out without a fitting at the very bottom of the tank, and we weld pipe supports to the tank to carry the weight of the piping.

OptionWhere the pipe entersUse it when
Top fill lineThrough the topYou want to fill from ground level with no sidewall fitting.
Top drain lineThrough the topYou want to pump liquid out with no sidewall or bottom fitting, such as on a double wall tank.
Siphon tubeA sidewall fitting set above the bottomYou want the outlet off the bottom of the tank but still need to draw liquid from near the bottom.

Top drain (discharge) lines

A top drain line works like a top fill line in reverse. A pipe runs down inside the tank to just above the bottom, comes out through a fitting on the dome, and runs down the outside of the tank to working height. Your pump connects there and draws the liquid up and out, so neither the inner nor the outer wall of a double wall tank has a hole below the liquid.

  • Foot valve at the bottom of the inside pipe holds the line full of liquid so the pump stays primed.
  • Capped tee at the top of the line, so the line can be filled to prime it.
  • Ball valve at working height to open and close the line.
  • Male camlock with dust cap for a quick hose or pump connection.
  • Welded pipe supports along the outside of the tank.

Top drain lines are built in Schedule 80 PVC or CPVC, matched to the chemical and temperature. Which options come in PVC or CPVC

Top drain line spec sheet (PDF)

Drawing of a tank top drain line with capped tee, ball valve, male camlock with cap and foot valve
Top drain line: capped tee, ball valve, camlock and foot valve.

Siphon tubes

A siphon tube threads into the inside end of a sidewall fitting and turns down toward the bottom of the tank. That lets you put the outlet a little way up the sidewall, where it is easier to reach and plumb, and still draw liquid from near the bottom so less is left in the tank.

Siphon tubes come in short and long lengths to suit the height of the outlet, and we make them in PVC or CPVC to match the rest of the fittings.

Siphon tube spec sheet (PDF)

Threaded siphon tube elbow for a plastic tank fitting
Short siphon tube.
Long threaded siphon tube for drawing liquid from near the bottom of a tank
Long siphon tube.

Welded pipe supports

Fill lines, drain lines and other piping are heavy, especially when full. Instead of letting that weight hang on the bulkhead fitting, we weld plastic pipe supports to the tank wall and clamp the pipe to them along its length. They are included with every top fill and top drain line we build.

Letting the weight of pipes or plumbing rest on an installed fitting can crack the fitting or the tank wall, and it voids the fitting warranty. If you add piping in the field, support it independently.

Welded pipe supports spec sheet (PDF)

Welded pipe support holding a gray PVC line with true union check valve and ball valve on a plastic tank
Welded support on a PVC line with check valve and ball valve.
Top fill and drain lines held by welded pipe supports on the side of plastic storage tanks
Supports along fill and drain lines.

Need fill and drain lines on your tank?

Tell us how the tank is filled and emptied, and we will build the lines, valves and supports at our plant. Request a quote · dmiller@plasticstoragetanks.com

★ Tank Wizard